There are two methods:
a) Fix the bracket to the wall using the dowels and screws provided and then
snap the detector onto the bracket.
b) Use the double-sided adhesive tape included in the pack and stick the
detector in the desired location.
3. Setting up the personal code
Once you have placed your batteries, you have 15 seconds to choose a
four-digit code. If you have not had time to enter your personal code, the
code 1234 will be saved by default.
Note: Each time you install batteries, you will need to set up your 4-digit
code again.
4. Keypad functionality
a) Home Mode: Enter your 4-digit code, then press the «1» button. You will
hear a «beep» to indicate that the alarm will enter «home» mode after 30
seconds.
NOTE: In this case, the motion detection function is disabled. Only the
magnetic door sensor will trigger an alarm.
b) Away mode: Enter your 4-digit code, then press the «2» button. You will
hear a «beep» to indicate that the alarm will enter the «Away» mode after
30 seconds.
NOTE: In this case, if someone opens the door or window equipped with the
opening detector or enters the field of vision of your motion detector, the
alarm will be triggered.
c) Emergency mode: Press buttons 1 and 4 simultaneously in an emergency.
An alarm will sound without time limit to scare off intruders.
EN