Chacon Medicine cabinet kit Manual De Uso página 36

5. Combining your alarm unit with other accessories
1. Using a screwdriver, open the battery compartment of the main unit.
2. Press and hold the learn button until you hear a «beep». The unit enters
pairing mode. (see diagram point 1)
a. Remote control: Press any button on the remote control. You will hear a
«beep» sound to indicate that the pairing was successful.
b. Opening detector: Separate the two parts of the opening sensor to send
a signal to the main unit. You will hear a «beep» indicating successful
coupling.
c. Motion detector with or without code: Wave your hand in front of the
motion detector. You will hear a «beep» indicating successful pairing.
d. Remote keypad: Press any button on the remote keypad. You will hear a
«beep» indicating successful pairing.
3. To exit pairing mode, press and hold the learn button for 3 seconds. You
will hear a double «beep»
NOTE: A maximum of 32 transmitters can be paired to a main unit.
6. Reset pairing
In order to reset your entire alarm, remove the batteries from your device.
Then press and hold the learning button of your central unit. When you
reinsert the batteries, you will hear two «beeps» indicating that the reset
was successful.
7. A 100% compatible ecosystem
We have created a 100% compatible alarm system to meet your needs.
Here, we offer accessories that can work alone but also as a kit. This
allows you to personalise your alarm and to associate several accessories
but also several alarms between them. For example, when a person trig-
EN