Troubleshooting Guide - NuWave INFINITY 28202 Manual Del Propietário

CLEANING & MAINTENANCE
Before First Use
Wash all removable parts in warm, soapy water or in the
dishwasher, top rack only. The Jar can be washed using the Clean
function. See "Instructions" for details.
Plunger Cap
Plunger
Jar with Blade
Lid Seal Ring Assembly
It may be necessary to remove the Lid Seal Ring for occasional
cleaning or to replace the part if it becomes worn or damaged.
To assemble:
1. Line the inside of the Lid Seal Ring into the rim.
2. Press the Seal Ring into the rim to ensure it is properly sealed.
3. Make sure the lower part of the Seal Ring lines up with the
bottom side of the rim.
Plunger Lid Rim
Do not immerse Infinity Blender
™
Base in water. Clean with damp
sponge or cloth and wipe dry.
18
cleaning & maintenance
Plunger Lid
Seal Ring
Seal Ring

TROUBLESHOOTING GUIDE

Silicone Pad Removal
It may be necessary to remove the Silicone Pad for occasional
cleaning or to replace the part if it becomes worn or damaged.
To remove:
1. Lift up one corner of the Silicone Pad.
2. The Silicone Pad is tightly secured so make sure to carefully
pull out the Pad until it is removed.
Silicone Pad Cleaning
The Silicone Pad is dishwasher-safe, top rack only. It can only be
hand washed with warm soapy water.
TROUBLESHOOTING GUIDE
The Infinity Blender was engineered with an automatic shut-off
™
feature to prevent overheating during use. If the Infinity
shuts off to cool itself down, an odor may be detected. Unplug the
Infinity Blender and wait for it to completely cool down. To prevent
™
overheating, do not process at speeds not recommended.
The Infinity Blender is not turning on or working.
™
1. Plug may not be in the outlet. Plug in the Infinity
an appropriate power source.
2. The Red Power Switch on right side of Base may not be on.
Check to see if the Power Switch is on.
The Infinity Blender does not work when plugged in and
™
Power button and Power Switch are both ON.
The Lid is not on the Jar properly. Line up red dot on top of the
Lid with the Jar's handle and press the Lid down firmly to secure
onto the Jar.
The Infinity Blender is not running at a high enough speed
™
for the recipe.
1. The Dial is not on the correct setting. Turn the Dial to proper
setting based on the recipe.
2. The Jar is overloaded. Reduce the amount of your
ingredients.
Blender
™
Blender into
™
19
nuwavenow.com