Asist AE9CT60 Instrucciones De Uso página 51

Possible defects
The following problems can occur during operation:
Disorder Possible reasons
1. After commissioning, the
body of the waterworks is not
yet full of water.
2. Insufficient tightness of the
supply line.
Pump 3. The non-return valve is
running but not blocked.
pumping water. 4. The suction basket is not
submerged
5. The exhaust pipe air is not
discharged because the water
outlet is closed.
6. Suction cant (> 8 m).
1. It has no power supply.
The electric motor 2. The fan cover prevents
hums but does not rotation.
work. 3. Blocked pump or damaged
motor
1. Suction height (> 8 m).
2. The suction basket is
Insufficient water
blocked.
is leaking.
3. Dirt has reduced the effective
performance of the equipment.
The heat-sensitive
switch does not 1. The pump is overloaded
switch off the because there is dirt in it
device.
Frequent switch-
1. There is no compressed air
ing on and off of
in the tank.
the device switch.
Problem solving
1. Fill the device with water.
2. Check the recommended, used parts and com-
ponents of the device, such as the supply pipe
connection, drain pipe connection, connecting
ring, supply pipe, etc., as well as the screw thread
sealing strip made of zteflon or hemp rope.
3. Clean the filter and the basic supply line valve.
4. When the device starts to suck, open the water
outlet (eg tap, spray nozzles, etc.).
5. Reduce the suction height.
6. Check the water level inside or in the water
tank.
1. Check the power supply.
2. Pull out the plug, remove the fan cover with a
screwdriver, then reattach it. Gently turn the blade
and check that it moves without obstruction.
3. If it is blocked, send the device to an author-
ized service center.
1. Check the suction head.
2. Clean the filter.
3. Immerse the suction basket in deep water.
1. Clean the pump.
2. Send the device to an authorized service
center for inspection.
1. Use a suitable valve and fill the tank with
compressed air at a pressure of 1.5 bar using
compressed air.
51