Cleaning And Maintenance - Steinberg Systems SBS-LZ-2000SLS Manual De Instrucciones

3. Brake setting (acceleration and deceleration)
Press the selection button [2] to pause time. BX will appear in the time display [10].
Set the brake speed using the increase [3] or decrease [4] buttons. The speed range is
from b0 to b9. The speed is set at b5 at the factory.
4. Starting centrifugation
Press the START button [6], the operation indicator [7] will brighten. The device will
start working. The speed display will show RPM and the time display will begin to
count down the remaining time. The device takes approximately 1 minute to reach
maximum speed.
5. Stopping centrifugation
When centrifugating is finished or the STOP button [5] is pressed, the time display will
show "0", the stop indicator [8] will light up and the speed display [9] will show "0".
You can open the lid and remove test tubes.
3.4.
a) Unplug the mains plug and allow the device to cool completely before each
cleaning, adjustment or replacement of accessories, or if the device is not
being used. Wait for the rotating elements to stop.
b) Use only non-corrosive cleaners to clean the surface.
c) After cleaning the device, all parts should be dried completely before using it
again.
d) Store the unit in a dry, cool place, free from moisture and direct exposure to
sunlight.
e) Do not spray the device with a water jet or submerge it in water.
f) Do not allow water to get inside the device through vents in the housing of the
device.
g) The device must be regularly inspected to check its technical efficiency and
spot any damage.
h) Use a soft cloth for cleaning.
i) Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal
spatula) because they may damage the surface material of the appliance.
j) Avoid places exposed to UV rays when working and storing the device. If
installation in such a place is not possible, after finishing work, cover the device
with a cloth to protect it.
SAFE REMOVAL OF BATTERIES AND RECHARGEABLE BATTERIES
1.5V AAA batteries are installed in the devices.
Manual rev. 10.02.2021

Cleaning and maintenance

10 of 12