EHEIM aquaclass Serie Manual De Instrucciones página 15

English
‧ The appliance must be protected by a residual current protection device with a maximum rated residual current of 30 mA.
Please contact an electrician if there are any questions or problems.
‧ In the event of leakage or when the residual current protection device is triggered, immediately disconnect all devices in
the aquarium from the power supply.
‧ If they are not being used, always disconnect all devices in the aquarium from the power supply before you install/remove
any parts and before all cleaning and maintenance work.
‧ Heed the operating manuals for the EHEIM thermopreset aquarium heater and the EHEIM aqua interior filter, especially
the chapters on safety, commissioning, operation and maintenance!
‧ Protect the mains socket and mains plug against moisture and wetness. A drip loop must be formed
with the mains cable. This prevents any water running along the cable to the mains socket, which
would result in a short-circuit.
‧ The electrical data of the appliance must match the data of the power mains. This data is found on the
type plate, the packaging and in these instructions.
‧ Note the distance from the underside of the light to the highest water mark. The aquarium must be
filled to a maximum of 2 mm above the lower edge of the cover frame (aquaclass 30 ⌦F) or up to the water level indi-
cator (aquaclass 66 ⌦G).
4. Preparation
Unpacking
‧ Carefully remove all components from the packaging and make sure that nothing is missing or damaged.
Accessories
The scope of delivery contains the following accessories:
aquaclass 30
‧ EHEIM thermopreset 50 aquarium heater (3652010)
‧ EHEIM aqua 60 interior filter (2206020)
aquaclass 66
‧ EHEIM thermopreset 100 aquarium heater (3654010)
‧ EHEIM aqua 160 interior filter (2207020)
5. Assembly
Location
‧ Avoid direct sunlight and not too much daylight!
‧ Keep the aquarium away from heat sources.
‧ Keep the aquarium away from electrical equipment.
‧ Be aware of any nearby mains connections.
CAUTION! Material damage.
▶ Ensure that the surface is level and stable.
▶ Ensure that the base cabinet is sufficiently stable.
▶ Be mindful of the floor load provided by the entire weight.
15