Hansgrohe AXOR Starck 10010 Serie Instrucciones De Montaje página 7

Assembly
The fitting must be installed, flushed and
tested after the valid norms!
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin / bidet.
3. Slip the fixation piece including the washer over
the threaded pin and tighten the nut.
4. Connect the supply pipes to the isolation valves;
cold right - hot left.
5. Connect the pull rod to the pop-up waste.
The hot and cold water supply's should be of equal
pressures.
Technical Data
This mixer series-produced with waterdim-
mer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer: 14 l/min 3 bars
Operating pressure:
Recommended operating pressure: 1 - 5 bars
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Test certificate:
10010XXX/10015XXX/
10200XXX
10011XXX /10016XXX/
Operation
open
English
7 l/min 3 bars
max. 10 bars
16 bars
max. 80° C
65° C
WRAS
0301038
WRAS
0209016
close
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
If the continuous water heater causes any problems
or there is not enough flow of water, the waterdimmer
(5a) located behind the aerator must be removed.
Spare parts (see page 3)
1 flange
2 handle Starck
3 handle Starck Puro
4 cartridge cpl.
5 aerator cpl.
6 pop up rod
7 connection hose
8 fixing set
9 extension hose 300 mm
10 lever arm cpl. 290 mm
Special accessories
X special tool set
(not part of delivery)
XXX = Colors
000 chrome plated
810 satinox
®
cold
96427XXX
10090XXX
10092XXX
96339000
94005XXX
94006XXX
96321000
94701000
13098000
96307000
58085000
hot
7