The Control Panel - Cinderella CLASSIC Manual Del Producto

3.6 THE CONTROL PANEL

The control panel is equipped with three LED lights that will tell the user about the status of the system. It is
important that all users familiarize themselves thoroughly with these signals before use. An overview of all the
light and sound signals can be found in the troubleshooting table in section 5.1.
NOTE!
• A green light indicates that the toilet is connected to the power supply. When only the
green light is lit, the toilet is on standby and ready for use.
• A yellow light indicates an ongoing incineration process and will light constantly while
the toilet is in incineration mode
• A red light indicates interruption and will alert the user that the toilet is no longer
incinerating or on standby.
Standby
Incineration mode
System interrupted
Emptying indicator
Your Cinderella Classic will indicate when the ash container is full and must be emptied. The yellow and red LED
lights will blink alternately and three beeps will sound when opening the lid. If the ash container is not emptied
within a short number of uses, the toilet will lock down. At this point the yellow, red and green lights will be
constantly lit and you will hear three short beeps every ten seconds until the ash container is emptied.
NOTE!
The ash container will usually only be half full when you get the indication to empty the ash,
you should still empty the ash as emptying it often improves the incineration efficiency.
15