Digital Outputs - Geutebruck G-ST 3000+ G2 Manual De Instalación

G-ST 3000+G2

Digital outputs

Assignment of the 25-pin Sub-D sockets
V 1.0
Each unit has eight (2 x 4) digital potential-free outputs. Like the digital inputs, these
are distributed to the two 25-pole Sub-D sockets (relay 1-4 and relay 5-8).
The digital outputs can be used, for example, to switch external devices to report
system errors. Corresponding events are created and set up in the G-Set
parameterization software.
The contacts can be soldered directly to the corresponding Sub-D plug. The assign-
ment of the 25-pin Sub-D connectors is shown in the following figure.
Figure 5: Assignment of the 25-pin Sub-D socket, solder-side
Connection
13 Normally open contact
25 Normally closed contact
12 Changeover contact
24 Normally open contact
11 Normally closed contact
23 Changeover contact
10 Normally open contact
22 Normally closed contact
9 Changeover contact
21 Normally open contact
8 Normally closed contact
20 Changeover contact
7
Ground
19 Switch input
6 Switch input
18
Ground
5 Switch input
17 Switch input
4
Ground
16 Switch input
3 Switch input
15
Ground
2 Switch input
14 Switch input
1
Ground
Changeover
contact
Signal Socket 1
Relay
Relay 3
Relay 2
Relay 1
8
7
6
5
4
3
2
1
Back to the
table of contents
Working contact
Break contact
Socket 2
4 Relay 8
Relay 7
Relay 6
Relay 5
16
15
14
13
12
11
10
9
15