Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
Important! The fitting must be installed,
flushed and tested after the valid norms.
1. Flush through the supply pipes.
2. Mount the fittings.
3. Push the level into the holes of the fittings and
align them.
4. Push on mixer and tighten allen srews.
11600XXX:
5. Mount the lever head and tighten the allen
screw.
6. Fit on screw cover.
The hot and cold supplies must be of equal pres-
sures.
Operation
The mixer is activated by pulling the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
11400XXX: The flow is changed from bath to shower
function by pulling the knob at the upper side of the
spout. After shutting off the water flow, the mixer
returns automatically to the bath function.
Technical Data
Operating pressure:
Recommended operating pressure: 1 - 5 bars
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Centre distance:
Connections G 1⁄2":
Rate of flow by 3 bars:
l/min
Back flow and vacuum breaker
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
6
English
To adjust the hot water limiter on single lever mixers,
please see page 13.
No adjustment is necessary when using a continuous
flow water heater.
Spare parts (see page 3)
1
2
3
4
5
6
7
8
9
10
10.1 screw cover
10.2 hollow set screw M6x10 DIN 916 96029000
11
12
13
14
15
16
max. 10 bars
16 bars
max. 80° C
65° C
153 ± 16 mm
cold right -
hot left
approx. 22
handle
aerator cpl. (10)
diverter knob
selector assy
cartridge cpl.
S - unions
non return valveDW 15
flange
interior spout
handle Arco
flange
nut
service set
packing kit (5)
mixer ball
cartridge cpl.
11091000
13485000
94102000
94103000
11095000
94136000
94074000
96464000
98559000
11691000
94063000
94130000
94106000
13952000
13962000
13964000
14096000
Publicidad
