Technical Specifications - Brasilia MAKI Instrucciones Para El Uso

TECHNICAL SPECIFICATIONS

- Voltage .......................................... V 220-240
- Frequency ............................................ Hz 50
- Input power: ...................................... W 1200
- Dimension (Ixpxh): ........... mm 205x307x265
- Rated capacity of tank: ........................... l 1,1
- Weight (approximately) ....................... kg 3,4
INSTRUCTIONS FOR USE
Read these instructions carefully, because
they contain important information about
safety of installation, use and maintenance.
Keep this booklet carefully for consulting
when you need it.
• Before using, check that the mechanical and
other parts of the machine are intact.
The body of the machine, tank lid, tank and
cartridge-holder unit must never be broken or
cracked.
The sheath and plug of the power cord must
never be cracked or broken. If this should
occur, disconnect the plug immediately and
take the machine to an authorised dealer for
checking.
• It is advisable to power the machine using a
contact breaker (RCD) with operating current
not higher than 30 mA.
• Keep the power cord out of the reach of
children.
• Make sure the machine is turned off before
plugging it into the wall outlet.
All manuals and user guides at all-guides.com
• The electrical safety of this machine is only
• Before plugging in the machine, make sure that
• Flying leads or non-approved extensions must
• Before using the machine, remove all protective
• The first time the machine is used there might be
• Never immerse the machine, power cord and
• Keep the power cord away from the hot parts
• While in operation, the power plug must always
• Do not disconnect the machine by pulling the
• Do not move the machine while it is working.
• Do not use or put the machine out of doors or
assured when it is connected to an efficient
earth system, in accordance with the safety
regulations in force.
Have this important requirement checked by a
qualified person.
The manufacturer cannot be held responsible
for damage caused by lack of an earth.
the electric power supply is the same as that of
the machine.
not be used for supplying electricity to the
machine.
films from the outside walls of its body.
some smell caused by the insulating materials
and the heating elements. This disappears after
a few minutes.
Do not leave the machine without water
in the tank.
plug in water or other liquids.
of the machine.
be easy to get at in case the machine has to be
disconnected.
power cord.
near water.
English
15