Battery Replacement; Selecting A Location - STACK-ON PS-1808-E Manual De Instrucciones

BATTERY REPLACEMENT

NOTE: Do not mix old and new ba�eries.
Do not mix alkaline, standard or
rechargeable ba�eries.
This safe uses 4 - AA ba�eries. Under normal
use, ba�eries will last about 1 year.
NOTE: If the ba�eries are low, the yellow light
will flash when you start to enter your code.
To replace the ba�eries, open the ba�ery
compartment on the back of the door by
pushing the tab in the direc�on of the arrow
and install all new ba�eries.
LOCKING THE SAFE
To lock the safe, close the door and turn the
knob to the le� to the 12:00 posi�on.
NOTE ON LOCKING THE SAFE: Because the
locking mechanism is deac�vated for
approximately 3 to 6 seconds a�er the
combina�on is entered, wait a minimum of
6 seconds from the �me the combina�on is
entered to lock the safe. Also, when locking
the safe, always make sure the knob is turned
completely to the le� to the 12:00 posi�on.
If the knob is not turned to the 12:00 posi�on
during the locking process, the locking
mechanism will not lock.

SELECTING A LOCATION

The safe must be mounted to a wall stud, and to
a permanent shelf or the floor. For op�mal
safety and security, the safe should be installed
in an isolated, dry and secure area.
THE SAFE SHOULD ALWAYS BE KEPT OUT
OF THE REACH OF CHILDREN.
SECURING THE SAFE
NOTE: This safe must be mounted to a wall
stud, and to a permanent shelf or the floor.
Failure to do so will compromise the safety
and security of the safe.
NOTE ON LOCKING THE SAFE: The safe needs to
be in an upright posi�on, as shown in figure 1,
for the locking mechanism to func�on properly.
Failure to mount the safe in the correct upright
posi�on will compromise the safety and
security of the safe.
Figure 1
PS-1808-E
PS-1814-E / PS-1814-EF /
SPSE1814BK22
PS-1815-E
PS-1820-E
40787-2205
3
12