Alessi Plisse Manual De Instrucciones página 57

TROUBLESHOOTING
• Problem
The kettle does not work correctly.
• Probable cause
- The voltage in your electrical
system does not match the voltage
specified on the bottom of the kettle
and/or on the power supply base.
- The kettle is not correctly placed
on the power supply base.
- The switch lever ON/OFF is not
in position ON.
- The kettle was switched on
without water.
- The kettle was switched on with
the lid open.
• Solution
- Check that the voltage in your
electrical system matches the voltage
specified on the bottom of the
kettle and/or on the power supply
base.
- Position the kettle correctly on
the power supply base so that
the power cable extends from the
slot on the kettle.
- Press the switch lever ON/OFF and
bring it to position ON.
- Pour cold water into the kettle,
wait about one minute, and then
start the heating cycle.
- Keep the lid closed during use.
• Problem
The kettle works erratically and
switches off before reaching the boi-
ling point.
• Probable cause
Lime has formed inside the kettle.
• Solution
Remove the lime (see paragraph:
Lime deposits).
Attention!: If the kettle continues to
malfunction, take it to your Alessi
dealer.
MDL06 Bollitore_MicheleDeLucchi_11-05-21.indd 49 MDL06 Bollitore_MicheleDeLucchi_11-05-21.indd 49
Spare parts
In case of wear, loss, or damage, you can
purchase the following replacement
parts at your Alessi dealer:
F Lime filter
G Power supply base
49
14/06/21 12:06 14/06/21 12:06