Machine Information - VONROC WS501AC Traducción Del Manual Original

EN
• Do not leave the unit unattended when switched
on.
• Liquid or steam must not be directed towards
equipment containing electrical components.
• Never submerge the unit in water or other
liquids or pour water over the unit.
• Never overfill the water tank past the MAX indi-
cator (maximum 4,5 litres).
• Make sure that the boiler is placed on a safe and
flat surface. Do not tip the boiler as there is a
risk of water entering the hose.
• Keep the cable away from heat and sharp edges.
• Do not place the boiler higher than ground level
e.g. on a step ladder or table.
• The boiler and the steam plate become hot
during use. Always hold the steam plate and the
boiler by the handles provided.
• Never detach the hose while the unit is switched
on. Allow to cool down for 10 minutes.
• Do not allow the hose to become kinked or bloc-
ked by de¬bris. In the event of a hose blockage
remove the plug from the wall socket.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate label.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm
cable reel, always fully unroll the cable.

2. MACHINE INFORMATION

Intended use
The wall paper steamer is developed for stripping
wall paper. The steam helps removing wall paper
without chemicals. This machine converts water
into steam.
TECHNICAL SPECIFICATIONS
Model No.
Voltage
Input power
Boiler Capacity
Weight
6
. If you use an extension
2
WS501AC
230-240V 50Hz
2000W
4.5 L
2 kg
Tube length
Tube diameter
Steam plate dimensions
Working time (4.5L)
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-3.
1. Boiler carrying handle
2. Boiler tank
3. Water level indication
4. Hose
5. Hose connector
6. Steam plate
7. Filler cap
8. Power cable
3. ASSEMBLY
Fitting the hose (fig. A and B)
• Screw one end of the hose (4) to the hose con-
nector (5) on the boiler tank (2).
• Screw the other end of the hose (4) to the
steam plate (6).
• Check that the hose has been connected
properly.
Initial filling of the boiler reservoir (fig. C)
Warning! Make sure that the appliance is
unplugged.
• Unscrew and remove the filler cap (7).
Note: When filling the boiler, use clean tap
water only.
• Fill the boiler tank (2) with water.
Do not overfill the tank past the MAX indicator
(maximum 4.5 litres) see fig. D.
• Place the boiler filler cap (7) back, do not over-
tighten.
• Place the steam plate (6) in a bucket before
starting the machine, never lay the steaming
plate flat on a surface always on its back see
fig. H.
Power cable (fig. E)
• Plug the connector of the power cable (8) in to
the machine.
• Plug the mains plug of the power cable (8) into
the power supply.
300 cm
22 mm
270x190mm
75 min
WWW.VONROC.COM