JNF IN.27.106 Manual De Instalación página 18

EN
6 - DELETE ALL NORMAL USER PASSWORD
Input "20 " ⇢ Inserir "MASTER USER PASSWORD " ⇢ BLUE LIGHT FLASHES ⇢ Input "4" ⇢ GREEN
LIGHT FLASHES TWICE
7 - UNLOCK
2 seconds
8 - WARM PROMPT
(1) If the lock batteries are low or input error, it will flash RED LIGHT.
(2) Password should be 3-12 digits, the first digit can't be "0". If the password is 12 digits, you don't need to
input " " to end.
(3) If the password group is max or the password group is zero, you can't add or delete password group, it will
flash RED LIGHT.
(4) When you delete single MASTER USER PASSWORD, the MASTER USER PASSWORD which uses to verify
can't be deleted, it will flash RED LIGHT.
(5) If you delete all MASTER USER PASSWORD, the MASTER USER PASSWORD will restore 11111111.
(6) When you ADD or DELETE USER PASSWORD, only can input "1" "2" "3" "4" option button.
Manual de instalação / Installation Manual / Manual de instalación
STEP 1
Press 2 seconds to wake up the system.
STEP 2
Put the password after JNF IS BLUE.
Note:
(1) After 6 times error try, the keypad will be locked for 3 minutes.
[When you touch the keypad, the RED LIGHT will flash twice]
(2) If you want to set ALWAYS OPEN, after unlocking the lock by password
[GREEN LIGHT is always on] and keep pressing the "0" button until the
GREEN LIGHT flashes. The GREEN LIGHT will flash 6 times, it means
ALWAYS OPEN setting is successful.
(3) After using the MASTER USER PASSWORD or NORMAL USER PASSWORD
to unlock the lock, the TEMPORARY USER PASSWORD will be deleted. If
you want to set the TEMPORARY USER PASSWORD again, please follow
step 4 "ADD TEMPORARY USER PASSWORD" to set.
- MI242-3 www.jnf.pt
18/30