Installing Additional Sata 6Gbps Hdd (2.5" Hdd) - Gigabyte BRIX Extreme Ultra Compact PC Kit Guia De Inicio Rapido

3-6

Installing Additional SATA 6Gbps HDD (2.5" HDD)

BRIX Extreme Unterstützt Zusätzliche SATA 6Gbps HDD(2.5 "Festplatte) /
Le BRIX Extreme supporte un disque dur SATA 6Gbps additionel: Comment l'installer /
Soporte adicional HDD 6Gbps SATA para BRIX s Extreme(HDD 2.5") /
BRIX Extreme Suporte adicional para HDD SATA 6Gbps(HDD 2.5") /
BRIX Extreme Supporta un' ulteriore porta SATA 6Gbps per HardDisk(HDD da 2,5")/
BRIX Extreme допускает установку дополнительного жесткого SATA-диска (6 Гбит/с): Порядок
установки 2,5-дюйм жесткого диска
BRIX Extreme wspiera dodatkowy dysk SATA 6Gbps HDD(2.5" HDD) /
BRIX Extreme , extra 6Gbps HDD destekler: 2.5'' HDD nasıl kurulum yapılır /
BRIX Extreme 支援額外的 SATA 6Gbps 硬碟(2.5" HDD) /
BRIX Extreme 支援额外的 SATA 6Gbps 硬盘(2.5" HDD) /
BRIX Extreme SATA 6Gbp ハードディスク(HDD) 増設(2.5 インチ HDD) /
BRIX Extreme 는 추가 SATA 6Gbps 을 지원합니다. HDD(2.5" HDD)
NOTE!
HDD can only be installed with its thickness less than 7mm.
Follow these instructions to install the 2.5" HDD:
1. Unscrew and remove the HDD bracket.
(將 HDD 支架從底蓋上移除)
2. Disconnect the SATA cable.
(取下主機板上的 SATA 線)
3. Screw the HDD and the bracket together with the four screws provided.
(用隨附的四顆螺絲將 HDD 與支架鎖起來)
4. Connect the HDD with the SATA cable.
(將 SATA Cable 與 HDD 相連)
5. Connect the other end of the cable to the SATA connector on the motherboard.
(將傳輸線的另一端接到主板上的 SATA 接頭)
6. Reinstall the bracket with HDD to bottom panel.
(將裝有HDD的支架 ， 鎖回底蓋上)
1
System Hardware Installation
- 33 -