Installing Lan/Com/M.2 Upgrade Kit - Gigabyte BRIX Extreme Ultra Compact PC Kit Guia De Inicio Rapido

3-7

Installing LAN/COM/M.2 Upgrade Kit

NOTE!
This system does not support the installation of both LAN/COM kit and 2.5" HDD; also the M.2
module here cannot be equipped with a thermal plate due to the space limitation.
Follow these instructions to install the Upgrade kit:
1. Unscrew and remove the bracket.
(將支架從底蓋上移除)
2. Disconnect the SATA cable.
(取下主機板上的 SATA 線)
3. Install the upgrade kit board onto the bottom panel using the four screws provided.
(用隨附的四顆螺絲將升級套件固定在支架上)
4. Connect the cable included in the upgrade kit to the upgrade kit board.
(將升級套件隨附的傳輸線接到升級套件上)
5. Connect the other end of the cable to the SATA connector on the motherboard.
(將傳輸線的另一端接到主板上的 SATA 接頭)
6. Reinstall the bracket with upgrade kit to bottom panel.
(將裝有升級套件的支架 ， 鎖回底蓋上)
1
System Hardware Installation
- 35 -