Operation Instruction; Installing The Wire Spool - Husky FC125LV Guía De Uso Y Cuidado

Operation Instruction

1
Preparing for Welding
□
Designate a work area that is clean and well lit. Keep
children and pets out of the work area.
□
Read the user manual and safety guidelines before
operating the welder.
□
Ensure you understand the basic speci ation of your
welder.
□
Wear PPEs to protect your eyes and skins from hot welding
sparks and intensive arc rays. Ensure same protections are
provided to any bystanders nearby.
□ Ensure all the combustible, ammable, hazardous
substances are removed from the work area. Make sure a
re extinguisher within reach is available.
□
Inspect your welder before each use and do not operate a
welder with damaged cables and components. Replace all
the damaged parts before use. Have a quali ed technician
to help you if needed.
2

Installing the Wire Spool

□
Make sure ON/OFF power switch (H) is OFF and unplug the
welder before proceeding.
□
Open the welder case by pushing the buckle (I) located on
the top panel (J).
□
Unscrew the spool cap (1), and remove spring (2), and
spool plate (3).
□
Place the wire spool (4) on the wire spool spindle in a
manner as shown on the right.
NOTE: The wire spool should rotate in a counterclockwise
direction when operating.
□
Place the spool plate (3), spring (2) and the spool cap (1)
back to the wire spool spindle.
□
To make sure wire spool can spin properly, avoid
overtightening or insuf
Overtightening may cause inconsistent wire feeding while
insuf ent tightening will cause uncontrolled wire feeding.
□
Next, please check the "Welding Wire Setup" to feed the
welding wire through MIG gun.
ent tightening of the spool cap.
WARNING: Welding processes generate high-
temperature arc, welding sparks, hot slag and hot
spatters. Welding arc generates extremely intense
ultraviolet and infrared light. Failure to wear protective
equipment during welding can severely damage your
eyes and burn your skin.
WARNING: Failure to protect combustible materials
against welding sparks, hot slag and hot spatters can
cause
cause death, injury and property damage.
1
2
3
4
Figure 1．Wire Spool Spindle Assembly
8
e and even explosion. Fire and explosion can