Domo DO91122 Manual De Instrucciones página 49

· Before connecting your refrigerator to the power supply, check that the voltage stated on the rating
label of your appliance corresponds to the voltage in your home. A different voltage could damage the
appliance.
· After installation, leave the freezer for 24 hours before turning it on. This way the refrigerant can
settle.
· Allow the appliance to run empty for 12 hours so the compartment can cool to the appropriate
temperature.
· One can level the appliance using adjustable legs. The adjustable legs can be adjusted by screwing
them in or out of the appliance.
· Install the handle.
· The climate class indicates the minimum and maximum ambient temperature for the proper operation
of an appliance. You can find the climate class on the type plate on the back of the appliance.
· SN: Subnormal: ambient temperature between 10°C and 32°C
· N: Normal: ambient temperature between 16°C and 32°C
· ST: Subtropical: ambient temperature between 16°C and 38°C
· T: Tropical: ambient temperature between 16°C and 43°C
RUBBER SUPPORT FOOT
If the refrigerator is (almost) empty and pressure is put onto the open door, the appliance may tip
forward. You can fasten the rubber support foot to the bottom of the door to steady the appliance and to
prevent the door from getting damaged.
· Disconnect the mains plug from the mains socket.
· Carefully tip the appliance backward so that the hole for the rubber
support foot can be reached.
! Attention: the inclination of the refrigerator must be less than 45°
so that the compressor oil does not enter the cooling circuit. If you do
shut down the unit completely, wait 8 hours before turning it back on.
· Put the supplied screw into the opening of the rubber support foot
and fix the rubber support foot in the hole at the bottom of the door with a cross-tip screwdriver.
www.domo-elektro.be
Lift Lower
16
49
DO91122