Controls; Turning On Bluetooth; Selecting Wi-Fi - Monogram ZGU36ESLSS Manual Del Propietário

USING THE COOKTOP

CONTROLS

Timer
As a part of the power up sequence, the control lights up
all the display elements. To start the timer, tap the Timer
Start/Off pad once which prompts the use to start adding
time.
+ pad.
A single tap on the +/- pads results in a 1 minute change in
time. Pressing and holding the +/- pads will automatically
from a running timer as long as the control is not locked by
tapping the +/- pads. After adding time, wait for 3 sec until
the timer starts count down automatically or to start the
timer immediately, tap the Timer Start/Off pad once.
This feature can only be used after all the knobs on the
cooktop have been turned off. If a knob is on, attempting to
activate this feature produces a chime and this feature is
not activated.
To lockout the flow of gas to the cooktop and to lock
the control, press and hold the Lock Control pad for 3
seconds until a beep is heard. After the beep the pad must
be released within 5 sec to activated this feature. Upon
will start blinking and depending on the state will stay lit
(locked) or turn off (unlocked).

Turning on Bluetooth

Press and hold the
pads at the same time until a beep is heard.
Release both pads after the beep to enter the pairing
mode for Bluetooth®.
The current state of the Bluetooth® is displayed, tap on the
+ pad to toggle the state.

Selecting Wi-Fi

Upon entry into pairing mode, the display shows the
current state of the Bluetooth® signal.
Tap the – pad to see the current state of the Wi-Fi signal.
Tap the + pad to toggle the state of the Wi-Fi signal.
10
– pad.
®
and Timer Start/Off
To cancel a running timer and turn it off, tap the Timer
Start/Off pad once at any time. Once the timer finishes
count down, it expires. It then starts flashing the display
and starts producing a notification tone of five beeps until
the user either adds more time to the timer or taps the
Timer Start/Off pad to cancel it and turn it off.
It is possible to use the lockout feature while the timer
is running. Once the control is locked, the timer can't be
turned on again until the control is unlocked.
The control and the flow of gas can be unlocked at any
time by repeating the procedure used to lock.
If no selection is made on this screen within5 seconds,
this screen times out and exits the pairing mode. Repeat
pairing mode sequence to return to this screen.
If no selection is made on this screen within 5 seconds,
this screen times out and exits the pairing mode. Repeat
pairing mode sequence to return to this screen.
49-2001105 Rev. 0