Installing And Removing Filters - Wilfa FRESH AP-100CW Manual De Instrucciones

UV-C/AUTO BUTTON
EN
• Press the button to turn on the UV light.
• Press the button one more time to turn on the AUTO mode. The air purifier
automatically changes the speed according to the air quality detected by
the dust sensor.
• Press a third time to turn off the UV light.
• Press a fourth time to turn off the AUTO mode.
• Press and hold this button for 3-5 seconds to enter night mode. In night
mode all indicator lights switch off, and the speed is on the lowest setting.
• Press any button to end night mode.
TIMER BUTTON
Press this button to set a timer. Choose between 2, 4 or 8 hours. When the time
is up, it stops automatically.

INSTALLING AND REMOVING FILTERS

FILTER REPLACE INDICATOR
When the filter replace indicator light lights up, it is time to replace the filter.
Replace the filter according to the directions below. Then press and hold the
POWER button for 3-5 seconds to restart the system, and the filter replace
indicator light will turn off.
1. Turn the unit upside down.
2. Screw out the screw on the bottom.
3. Remove the base cover.
4. Remove the filter and replace it with a new filter.
5. Place the base cover and insert the screw before you turn the unit.
Note: The combination filter will last approximately 6 months.
INSTRUCTION MANUAL · FRESH
8