Lionelo Sven Plus Manual Del Usuario página 9

top to get rid of the pointed shape, which is picked up in the carton (see fig. 7, 8).
The mosquito net may only be used with the canopy folded out. If you want to fold
the canopy - detach the mosquito net.
Changing table assembly instruction
Slide the stiffening tubes into the cloth rewinders. Combine them with additional pipes
with plastic fasteners. Fasten the material with all the naps, pull it firmly on the resulting
frame. Insert the plastic fastening elements on the longer sides of the cot, insert additional
fasteners in the shorter side of the bed. Fasten the organizer's naps on dedicated places
on the bed frame, stretching the organizer's material at the changing table (see fig. 9).
Organizer installation
Put the hooks on the organizer and mount it on the bed frame (see Fig. 11a, 11b).
Baby bed folding instruction
1.
Remove all the bed accessories. Remove the mattress, canopy, organizer and
all the other accessories. Grasp the centre handle located in the middle of
the floor and pull it up (see fig. 12).
2.
To unlock the upper rails, press the indicated buttons on each side of them.
Pull it slightly up and then push it down. Unlock the shorter sides first, and
then do the same with the longer ones.
3.
While still pulling up the handle, lift the floor of the baby bed and fold the
legs (see fig. 13).
4.
Wrap the folded bed with the mattress and fasten it with Velcro straps.
Put the folded baby bed into the bag (see fig 14, 15.).If the installation is
unsuccessful, repeat the whole process again until submission
Cleaning
Wipe the product with a damp cloth, then allow to dry.
Changing table - clean with warm water and mild soap. Do not dry clean and do
not use caustic agents. Do not dry mechanically, do not iron.
The product has been tested and meets all the requirements of the:
EN 716-1:2017+AC:2019, EN 12221-1:2008+A1:2013
‑ 9 ‑ EN