Layout; Depicted Components; Symbols; Operation - Mafell A12 Traducción Del Manual De Instrucciones Original

4

Layout

4.1 Depicted components

(see Fig. 1)
(1) Exchangeable attachment (chuck)
(2) Adjusting ring – torque preselection
(3) Gear change slide - first or second gear
(4) Sense of rotation selector switch, double sided
(5) Bit adapter
(6) Belt clip, can be used on both sides
(7) Button - capacity display
(8) Rechargeable battery
(9) Capacity and signal display
(10) LED light
(11) Switch trigger

4.2 Symbols

Nm
5

Operation

5.1 Rechargeable battery, capacity and signal
display
(see Fig. 1)
•
Charge the rechargeable battery prior to use.
•
Recharge the rechargeable battery in case of
loss of power.
•
Press the button (7) to query the charge
condition of the rechargeable battery. The
capacity can be read off the LED lights (9).
•
If a LED light (9) flashes, the rechargeable
battery is almost empty. Recharge the
rechargeable battery.
•
The optimum storage temperature is between
10 °C and 30 °C.
Movement direction
First gear
Second gear
Screwing
Drill bit
Torque
5.2 Removing and inserting the rechargeable
battery
(see Fig. 2)
Removing: Press the unlocking mechanism (12) and
pull the rechargeable battery (8) out to the front.
Inserting: Push on the rechargeable battery until it
clicks into place.

5.3 Sense of rotation, transport lock

(see Fig. 1)
R = Clockwise rotation
L = Anti-clockwise rotation
0 = Centre position: Transport lock
(Switch-on lock)

5.4 Selecting the gear speed

(see Fig. 1)
Actuate the switch slider (3) only
when the motor is standing still!
First gear: low speed, high torque;
preferably for screwing
Second gear: high speed; preferably
for drilling

5.5 Setting the torque

(see Fig. 1)
Set the torque by turning the adjusting ring (2).
1...10 = Torque limiting (setting range 0.5 - 5
Nm)
= Adjusting the drill setting (max. torque,
without torque control). Do not block the
spindle to avoid overloading the motor.

5.6 Switching on/off, setting the speed

(see Fig. 1)
Switching on: Press the switch trigger (11) and keep
it depressed. The speed at the switch trigger can be
changed by the depth to which it is depressed.
Switching off: Release the switch trigger (11).
-19-