Tool Change; Switching The Led Light On/Off; Belt Clip; Bit Adapter - Mafell A12 Traducción Del Manual De Instrucciones Original

5.7 Tool change

Only use high-grade tools, which
are suitable for the forces and
torques occurring! Broken tools will
lead to a machine defect. If repairs
are necessary, contact the
customer service stations for
MAFELL electrical tools.
The spindle enables a quick change between the
accessory attachments and a direct ¼'' hexagonal
adapter.
Demounting the attachment: (see Fig. 3) Pull the
locking ring (13) forward and pull off the attachment
to the front.
Mounting the attachment: Pull the locking ring (13)
forward and push the attachment onto the spindle up
to the limit stop. (If necessary, turn the attachment
slightly to and fro.)
Turning the attachment: With the angle and
eccentric attachment (optional accessories) you can
adjust the angle of the attachment in 30° steps to the
screwdriver axis.
Pull the locking ring (13) forward and push the
attachment onto the spindle into the desired position
until it clicks into place again.
5.7.1 Quick-release chuck
(see Fig. 1)
Opening the chuck: Turn the chuck (1) in direction of
rotation .
Place the bit as deeply as possible into the open
chuck. Turn the chuck (1) in direction of rotation
until the tool is firmly mounted.
5.7.2 Angle attachment
The angle attachment can be used to work at right
angles to the screwdriver axle.
Mount the bits directly by means of the ¼'' hexagon
adapter or by attaching the chuck or bit holder.
5.7.3 Quick-release
accessories)
Inserting the bit: Push the bit into the bit holder until it
audibly clicks into place.
Removing the bit: Pull the sleeve at the bit adapter
forward until it clicks into place and remove the bit.
bit holder (optional
5.7.4 Eccentric
accessories)
With the eccentric attachment it is possible to work
close to the edge of inside corners.
Inserting the tool: Pull the sleeve at the adapter
backwards and insert the tool up to the stop into the
¼'' hexagon adapter.
Removing the tool: Pull the sleeve at the adapter
backwards and remove the tool.

5.8 Switching the LED light on/off

(see Fig. 1)
•
Press the switch trigger (11) to switch on the
LED light (10).
•
After releasing the switch trigger (11), the LED
light (10) still glows for approx. 5 sec. and then
switches off.

5.9 Belt clip

For an easier handling of the belt
clip, remove the rechargeable
battery (see chapter 5.2)
(see Fig. 4)
Detaching:
•
Press the belt clip (6) together at the rear.
•
Swivel it out of the rear opening.
•
Slacken the belt clip and remove it from the front
opening.
Attaching:
•
Press the belt clip (6) together and insert it into
the openings provided.
•
The belt clip (6) can be attached on both sides.

5.10 Bit adapter

(see Fig. 1)
A screw bit can be fitted in the bit adapter (5) on both
sides.
-20-
attachment (optional