Technical Data; Ec Declaration Of Conformity - Cramer 2000986 Manual De Instrucciones

EN
Problem
The machine does
not start.
The machine does
not start when the
battery pack only
has one or two
lights flash.
The motor runs,
but the chain does
not cut correctly,
or the motor stops
after around 3 sec-
onds.
Possible cause Solution
Pull the chain
The chain brake is brake in the direc-
engaged. tion of the user to
disengage it.
Make sure that the
The machine and
battery release
battery are not
button clicks when
connected correct-
you install the bat-
ly.
tery pack.
The battery level Charge the battery
is low. pack.
1. Push the lock-
out button and
The lock out but-
hold it.
ton and the trigger
are not pushed at
2. Push the trig-
the same time.
ger to start the
machine.
Refer to battery
The battery is too
and charger man-
hot or too cold.
ual.
1. The battery 1. Cool the bat-
pack is in a low tery pack or
capacity. machine to
ambient tem-
2. The battery
perature.
pack or control
2. Charge the
board at high tem-
battery pack
perature protective
again.
state.
3. Start the ma-
chine again.
Release the trigger
The machine is in
and start the ma-
the protection
chine again. Do
mode to protect
not force the ma-
the PCB.
chine to cut.
Charge the battery.
Refer to the bat-
The battery is not tery and charger
charged. manual for correct
charging proce-
dures.
Lubricate the
chain to decrease
the friction. Do
The chain is not not let the guide
lubricated. bar and the chain
operate without
sufficient lubri-
cant.
Cool the battery
Incorrect battery
pack until it de-
storage tempera-
creases to the am-
ture
bient temperature.
English
8

TECHNICAL DATA

Voltage
No load speed
Guide bar length
Chain stop
Chain oil capacity
Weight (without battery
pack)
Measured sound pressure
level
Guaranteed sound power
level
Vibration
Chain
Guide bar
Battery model
Charger model
9 EC DECLARATION OF
CONFORMITY
Name and address of the manufacturer:
Name:
Address:
Name and address of the person authorised to compile the
technical file:
Name:
Address:
Herewith we declare that the product
Category:
Model:
Serial number:
Year of Construction:
• is in conformity with the relevant provisions of the
Machinery Directive 2006/42/EC.
• is in conformity with the provisions of the following
other EC-Directives:
• 2014/30/EU
• 2000/14/EC & 2005/88/EC
10
48 V DC
20 m/s
360 mm
< 0.12 s
200 ml
3.6 kg
L = 94 dB(A), K
pA
dB(A)
L = 108 dB(A)
wA.d
2
12.2 m/s , K = 1.5 m/s
90PX052X
144MLEA041（ 554557）
48V192 and other BAM ser-
ies
48C and other CAM series
GLOBGRO AB
Globe Group Europe
Riggaregatan 53, 211 13 Malmö, Sweden
Micael Johansson
Riggaregatan 53, 211 13 Malmö, Sweden
Chainsaw
48CS18
See product rating label
See product rating label
= 3
pA
2