Connecting The Wiring; Adjusting The Camera - Honeywell HD4VC4HR Guia Del Usuario

Connecting the Wiring

Follow Figure 4 for the wiring connection.
Figure 4 Wiring Connection
Video: female BNC

Adjusting the Camera

To adjust the HD4VC4HR Camera:
1. Apply 12 VDC or 24 VAC to the camera and monitor the video signal.
2. Loosen the screws that lock the gimbal assembly in place (see
3. Adjust the camera carrier to the desired view.
4. Tighten the screws to lock the gimbal assembly in place.
Note Orient the camera as shown in
orientation.
Rev 1.02
Power
Red
Black
_
+
Figure 5 to maintain the correct picture
7
Note For secure installations, surface
mounted cables should be
protected by plastic or metal
cable covers.
Figure 5).
Document 900.0556
01/06