Operation - CASO DESIGN IceChef Pro Manual Del Usuario

8 Clean – Select the cleaning function
9 S/L – button for selection of the size of the ice cubes
10 Start / stop - button

15.2 Operation

► Please wait min 24 hours before you switch on the ice maker. You will find that the
cooling agent settles out in this time.
 Open the cover of the ice maker and remove the ice basket.
 Check that silicon plug is correctly placed in water outlet.
 Fill water into the water reservoir and observe the max marking. Close the lid of the
device.
 Press the Start/stop button to begin the ice making cycle.
 Press the S / L button and select the desired ice cube size. S = small and L = large. The
corresponding indicator lights up. Default selection = large ice cubes.
► If the room temperature is below 15 ° C, then please select the small ice cube size.
► If the room temperature is above 30 ° C, then please select the large ice cube size.
 Depending on water and room temperature, the ice making cycle lasts approx. 6 to 13
minutes.
 If water pump can't inject water, the ice maker will stop automatically (after 5 seconds).
The indicator for the watertank lights up. Press the Start/stop button and fill the
tank with water.
 The ice maker stops working when the ice basket is full. In this case the
indicator will light up.
 Drain all the water, if unit isn't used. Always store the unit without water in the water
reservoir.
Please note
Please note
37