Kathrein UFO DVB-S2-QAM Manual De Instrucciones página 19

1.10 Selecting the modulation signal for the QAM modulator
The modulation signal (modus) for the QAM modulator is selected in the QAM stage sub-menu
The output signal QAM stage is selected using the "<" and ">" buttons.
Pressing the "Sub-menu" button
The QAM mode is selected using the "<" and ">" buttons and set using the "+" and "-" buttons.
O1 1236 MHz
27.500 MS/s
Outp. S21
6.900 MS/s
Main menu
The following settings are available:
Mode
O1
Outp. S21
6.900 MS/s
Main menu (display in PRBS mode)
The output symbol rate can be set in PRBS mode.
Note:
Simple signal meters can be used to measure the output level in CW mode.
O1
Outp. S21
-.--- MS/s
Main menu (display in the CW mode)
1.11 Transport stream processor: Programme fi lter
The function "Transport stream processor: Programme fi lter" is available via the UFG 300 hand controller from
Note:
software versions V4.1 and UFX 314 onwards.
O1 1236 MHz
27.500 MS/s
Outp. S21
6.900 MS/s
Main menu
All manuals and user guides at all-guides.com
displays the sub-menu and pressing the sub-menu button again exits it.
TP
3/4 QPSK
306.00 MHz
QAM
256
Normal mode, the satellite input signal is transmodulated. If there is a fault on the input
SAT Sig
signal, only fi ll bytes (0xFF) will be modulated
Test mode. The QAM signal is modulated with the PRBS-23 sequence.
PRBS
Normal mode is unavailable in this setting
Test mode. Sine-wave signal for levelling using simple signal meters.
CW
Normal mode is unavailable in this setting
PRBS
306.00 MHz
256 QAM
CW
306.00 MHz
256 QAM
P TP
3/4 QPSK
306.00 MHz
! 256 QAM
** UFO 378TP-O1
Mode SAT Sig
"QAM stage" sub-menu
** UFO 378TP-O1
Mode
"QAM stage" sub-menu (for setting PRBS)
** UFO 378TP-O1
Mode
"QAM stage" sub-menu (for setting CW)
*** UFO378TP-O1
Filter
IDs
"Transport stream processor" sub-menu
8 / 11
.
**
**
PRBS
**
CW
***
On 42 %/51 %