Technical Data; Preparations At The Workplace; Inserting The Battery - Hilti SF 10W-A22 Manual De Instrucciones

Battery charge status cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given in the Troubleshooting section.
3.5 Items supplied
Drill / driver, side handle, operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4

Technical data

4.1 Technical data
Rated voltage
Weight including battery B22⁄8.0
Speed
Torque range (15 settings)
Ø drill bit (softwood)
Ø drill bit (hardwood)
Ø drill bit (metal)
4.2 Battery
Battery operating voltage
Ambient temperature
Storage temperature
Battery charging starting temperature
5

Preparations at the workplace

WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1

Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
*2130486*
2130486
21.6 V
7.3 lb
(3.3 kg)
1st gear 0 /min ... 310 /min
2nd gear 0 /min ... 530 /min
3rd gear 0 /min ... 1,210 /min
4th gear 0 /min ... 2,100 /min
1 ftlb ... 9 ftlb
f
(2 Nm ... 12 Nm)
1/16 in ... 1 7/8 in
1/16 in ... 25/32 in
1/16 in ... 1/2 in
21.6 V
14 ℉ ... 140 ℉
(−10 ℃ ... 60 ℃)
−4 ℉ ... 104 ℉
(−20 ℃ ... 40 ℃)
14 ℉ ... 113 ℉
(−10 ℃ ... 45 ℃)
f
English 7