Insignia NS-IMC44S3 Guia Del Usuario página 14

PROBLEM POSSIBLE CAUSE
The (ice full) Too much ice in the ice
basket.
indicator lights
The ice making The room temperature or
cycle is normal, water temperature may
but no ice is be too high.
made
The refrigerant liquid may
have leaked.
A pipe in the cooling
system may be blocked.
The ice making cycle is
too short.
The ice cubes The ice cycle is too long
stick together for the room
temperature.
My ice maker The hot air outlet is
makes ice too blocked.
slowly
The water temperature in
the water reservoir is too
high.
The refrigeration system
is malfunctioning.
There is no water The holes in the separator
pipe are blocked.
in the water
separator pipe
The ice cubes are The ice making cycle is
too long.
too thick and
can't drop into
the ice basket
The ice cubes are The ambient temperature
is too high.
too thin
There is a refrigerant
system leak or blockage.
My ice maker is The drain plug is loose or
leaking water missing.
A pipe joint in your ice
maker may be loose.
The seal has reached the
end of its service life.
"E1" appears on The ambient temperature
sensor is not working.
the display
"E2" appears on The water temperature
sensor is not working.
the display
14
POSSIBLE SOLUTION
Remove some ice from the ice basket.
The room temperature should be no higher than
86° F (30° C). The water temperature should be no
higher than 77° F (25° C) and no lower than 50° F
(10° C).
Contact a qualified service technician for repair.
Contact a qualified service technician for repair.
Press the + button to lengthen the ice making
cycle.
Stop your ice maker, and restart it when the ice
blocks melt. Press the - button to shorten the ice
making cycle.
Check the hot air outlet and remove any
blockage.
The water temperature should be no higher than
77° F (25° C) and no lower than 50° F (10° C).
Have your ice maker serviced by a qualified
technician.
Use a thin wire or paper clip to clean the holes in
the water separator pipe
Press the - button to shorten the ice making cycle.
Move your ice maker to a cooler place. The
temperature should be no higher than 86° F
(30° C). The water temperature should be no
higher than 77° F (25° C) and no lower than 50° F
(10° C).
Have your ice maker serviced by a qualified
technician.
Replace the drain plug into the drain line.
Have your ice maker serviced by a qualified
technician.
Have your ice maker serviced by a qualified
technician.
Have your ice maker serviced by a qualified
technician.
Have your ice maker serviced by a qualified
technician.
www.insigniaproducts.com