WAGNER HAWAII Manual Del Usuario página 14

GB
INSTALLATION
● Select a place with as much sunlight as possible for the installation of the solar station.
● Do not place the solar station in the shade of trees, bushes or buildings, as otherwise
the performance of your Solar Fountain Set will be greatly impaired ( )
● Point the solar station facing south.
☞ ☞ The solar station can be set at an angle ( ):
Summer:
Spring and autumn:
ASSEMBLY SOLAR STATION
ATTENTION! Do not apply pressure to the solar panel as this could damage the solar
module!
● Remove the Solar Fountain Set carefully from the box.
NOTE: The connecting cable is fitted water-tight in the pump housing.
WARNING! When digging and drilling holes, ensure that you do not come into
contact with hidden supply lines. Contact with hidden supply lines
can lead to serious injury or even death.
● Carefully place the pump, stand and earth spike beside the installation site.
● Unwind the connecting cable of the pump. Feed the cable into the earth spike from
below and pull the plug out of the opening in the middle of the stand (Fig. A, 5, 4, 3).
● Drive the earth spike into the ground by hand.
● Push the stand onto the earth spike. Pull up any slack of the cable on the earth spike
in order to prevent the cable from becoming trapped.
● Push the solar station into the guide rail on the stand (Fig. A, 2, 3).
● Lay the cable in such a way that it cannot be damaged (e. g. by a lawn mower etc.)
● Stow away the unneeded length of cable by pushing it into the earth spike and stand
(Fig. A, 3, 4).
● Fit the covering cap (Fig. A,1) onto the stand and point the solar station facing south.
● Drive the stand into the ground by pressing on the covering cap.
ASSEMBLY
There ar two ways of operating the pump:
Assembly option I:
Assembly option II:
10
All manuals and user guides at all-guides.com
flat
steep
Floating
Immersed
HAWAII