Daily Maintenance - BaByliss PRO FXCHAMPKE Manual De Instrucciones

TO REPLACE CUTTERS
NOTE: Always replace the cutters
and foil head assembly at the same
time.
1. To remove cutters, place your fin-
gers on each side and gently pull
up and away from drive shaft.
2. To replace cutters, remove the
new cutters from their packa-
ging. Align cutter about the drive
shaft and lightly push down until
it snaps into place.
3. Replace the foil head assembly,
turn shaver on to ensure it is wor-
king properly.
GOOD
BAD

Daily Maintenance:

1. Press the release button on the
sides of shaver and remove the
head assembly (see Fig. 1 & 2).
2. Use cleaning brush to whisk
away any debris on and around
cutter (See Fig. 3).
3. Snap the head assembly closed
(see Fig. 4)
Fig. 1
Fig. 3
9
Fig. 2
Fig. 4