Front Panel - Sears Kenmore PG-40406S0L Manual De Uso Y Cuidado

Front Panel

Attach the two front panel sections together into a single front panel with (1) M4X10 screw as shown.
□
□ Attach the front panel to the cart by slipping the four panel holes on each side over and down onto the
four protruding screw heads on the left and right frames. Leave the top screw loose on each side, and
fully tighten the other three screws on each side.
Slide one end of the Right Drip Tray Support Bar "7A" under the front Right Frame top screw. Fully
□
tighten the screw. Fully tighten other end of bar to the rear Right Frame with (1)M4×10 Screw. (C)
Slide one end of the Left Drip Tray Support Bar "7B" under the front Left Frame top screw. Fully tighten
□
the screw. Fully tighten other end of bar to the rear Left Frame with (1)M4×10 Screws as shown. Install
and fully tighten (1) M4X10 screw through the middle screw hole on the bottom of the front panel into
the bottom shelf. (D)
M4x10 screws Qty: 4 pcs
A
B
C
D
21