Pump Installation - Sicce Syncra SDC 6.0 Manual De Instrucciones

PUMP INSTALLATION:

USE AND REGULATION
SYNCRA SDC can be remotely set up by using the controller or by
downloading the new SICCE CONTRALL App.( iOS-Android)
For the physical installation of the pump it is necessary to proceed
as follows:
- Unwind the power cord of the pump in an area where it will not be
damaged in any way.
1
- Join the connector of the pump's cable to the special T joint of the
controller's cable. On the other side of the "T" join the power supply
connector. Connect first the power supply cord to the transformer
and then to the power outlet. The transformer is universal and works
with all voltages and frequencies.
The pump is now powered but not active.
The controller must be positioned away from spray and moisture and
where it can not accidentally fall into the water.
The Controller can be attached to the wall or aquarium cabinet using
the included bioadhesive or screws.
- Connect the fitting to the pump' s outlet to which you can then
connect the flexible or rigid pipe of the Appropriate diameter.
- Place the pump in an easily accessible area for the maintenance
operations.
- If the pump is used submersed and not in line, it must be always
fully submersed. (Pic. 1)
INDEX
SYNCRA SDC · 6.0 · 7.0 · 9.0 INSTRUCTION MANUAL · EN