Safety Instructions - Sicce Syncra SDC 6.0 Manual De Instrucciones

SAFETY INSTRUCTIONS

SYNCRA SDC is made in conformity with the national and international safety standard
regulation.
1) Always isolate the pump from the mains electricity before installing or carrying out any
maintenance. Power to the pump must be supplied through a Residual Current Device (RCD)
with a rated residual operating current not exceeding 30mA.
2) The pump can work submerged or inline out of water. (impeller must always run wet)
3) Before connecting the pump to the electricity supply, check there is no damage to the cord
or plug.
4) The pump has a type Z cable link. The cable and the plug cannot be substituted or repaired;
A
in case of damage to the cable, the entire pump must be replaced.
5) ATTENTION: do not operate any Appliance if it has a damaged cord or plug, if it is
malfunctioning, or if it has been dropped or damaged in any way.
6) The pump must not work without water to avoid damages to the motor.
7) The pump can be used in liquids or in environment with a temperature not higher than 35
°C / 95 °F.
8) Do not use the pump for uses different to those for which it has been projected as, i.e. in
OUTDOOR USE
bathroom or similar Applications.
(10 m · 20 ft cable)
9) Avoid using the pump with corrosive and abrasive liquids.
10) This pump requires adult supervision.
11) To avoid that accidental drips wet the plug or the socket, make a loop with the cord under
the socket level (Pic. A).
12) To prevent any damage , avoid to take the pump by the cord during the installation or
maintenance.
13) The pump can be used only in the above mentioned Applications and it is only for internal
use, when the cable's lenght is shorter than 10mt or 10".
14) If the pump or the filter is supplied with a cable 10 meters long, or more than 6 feet long
for the American type (USA), these Appliances are intended for outdoor use as required by
international standards.
INDEX
SYNCRA SDC · 6.0 · 7.0 · 9.0 INSTRUCTION MANUAL · EN