Electrolux E9WHMIC1 Manual De Instrucciones página 12

12
4.
5.
To clean the cartridge and dispose of its contents, refer to Picture 6, 7, 8
6.
7.
To Lock/Unlock the cartridge, refer to Picture
4 and 5:
Lock (picture 4) / Unlock (picture 5).
and 9.
If the cartridge is fully clogged, it may be full
of dirty water.
In order to be prepared for the cleaning
operation, it is suggested to use any pot or
small plastic container; this could help the
operation and prevents the environment
around from getting wet.
To remove the remaining water inside the
cartridge, empty it out inside a pot or a
container by holding the assembly cover and
shaking it. The water flows out. In case some
water still remains, proceed with the next
step.
To reset filter, refer to Picture
7.
Before placing the cover back on the
cartridge, reset the floater by removing water
inside the cover. Hold the cover, rotate it (see
picture 7) and drain all the water into a plastic
container. The floater is no longer visible
when the cover is placed on the filter.
A noise could be heard but
this is normal behaviour since
inside the cover there is a
mass valve.