Yedoo ALLOY Manual Del Usuario página 13

14.
Adjusting the bowden cables (V-brake)
Adjust the position of the cables
and make sure they do not extend
outside the frame of the scooter
(especially in the rear fork area).
16a.
1 1
Adjustment of brakes - Trexx Disc
On the front as well as the rear wheel,
check, if the disc of the brake does
not scrape the brake pad. If so, loosen
the adjusting screws (1) and set up the
position of both pads so that their entire
surface would be parallel with the disc,
then fasten the adjusting screws again.
13
15a.
Fasten the end of the brake cable in
the lock and secure with the cable tie,
then trim the tie (applies to both front
and rear brake).
16b.
3
2
The distance between the brake pads
and the disc should be as small as
possible. You can set it up using an
adjustment roller (2), which adjusts the
tension of the brake wire. If this is not
enough, you may loosen the wire in the
anchor bolt (3).
15b.
17.
Anti-slip tapes
In case tapes become worn and
their anti-slip e ect is reduced,
we recommend replacing them.
Replacements tapes are available
to buy. See more on www.yedoo.eu.
Attention: Clean and degrease
the footboard thoroughly before
application.
EN