Installing Accessories; Auxiliary Handle - Bosch DH507 Instrucciones De Funcionamiento Y Seguridad

BM 1619929L06 06-12_BM 1619929L06 03-12.qxp 6/25/12 8:40 AM Page 8

INSTALLING ACCESSORIES

Clean the insert shank end of the accessory to
remove any debris, then lightly grease with a
light oil or lubricant.
Pull and hold locking sleeve backward. Insert
accessory into the tool holder through the dust
shield, while twisting and pushing inward until
it sets into place. Release locking sleeve to
lock bit in place. Pull outward on the
accessory to be certain it is locked into the
tool holder (Fig. 2).
NOTE: The high efficiency available from the
hammers can only be obtained if sharp and
undamaged accessories are used. The "cost"
FIG. 2
FIG. 3

AUxILIARy HANDLE

The tool must be supported with the auxiliary
handle, which can be swiveled 360˚. To
reposition and/or swivel the handle, loosen the
Assembly
to
accessories is more than offset by the "time
saved" in operating the tool with sharp
accessories.
and use proper protective gloves or cloth to
remove.
To remove an accessory, pull and hold locking
sleeve backward and then pull bit forward. All
accessories should be wiped clean after
removing (Fig. 3).
DUST SHIELD
hand grip, move the handle to the desired
position along the barrel and securely retighten
the hand grip (Fig. 1).
-8-
maintain sharp and
REMOVING ACCESSORIES
Accessories may be hot after
WARNING
use. Avoid contact with skin
LOCKING SLEEVE
undamaged