Troubleshooting - TRAPP TR 200 Manual De Instrucciones

In the first 5 hours
Change the oil of the crankcase
 
Every 8 hours or daily
Check the oil level
 
Clean the area around the muffler and the controls
 
Clean the protective screen
 
Every 25 hours or annually
Clean the air filter*
 
Clean the pre-purifier*
 
Every 50 hours o annually
Change the engine oil
 
Check the muffler and spark arrester
 
Annually
Replace the oil filter
 
Replace the pre-purifier
 
Replace the spark plug
 
Replace the fuel filter
 
Clean the air cooling system*
 
* In very dusty places or when particles brought by the air are present, clean more frequently.
Problem
Bushing of
themachine
Low production
Irregular cut of
the product
Difficulty in
starting the motor
44
Periodic Maintenance Plan of
Combustion Engine - TR 200G

Troubleshooting

Probable cause
Excess feeding. Due to this fact, the motor
does not manage to maintain the rotation
required and
the product accumulates inside
the machine (continuing with the use may
burn out the motor by overload).
Insufficient feeding of the machine
Lack of cutting edge to the knives
Voltage drop in the electrical network
Solution
Disconnect the equipment and
wait for the motor to stop. Open the
feeding funnel and clean the product
excess inside the machine, close the
feeding funnel, activate the motor, wait
for it to attain the maximum rotation and
restart the work, controlling the power
supply of the machine, so as not to
demand more than the motor capacity can
handle.
Control the feeding so that it is continuous,
but not in excess so as not to cause
bushing.
Sharpen the knives as indicated
in item Cutting blades maintenance
(page 39).
Check the conditions of the electrical
network (electrician).
www.trapp.com.br