Lindy 38205 Manual De Usuario página 7

User Manual
Troubleshooting
When Installation is complete, if there is no video being displayed, please consider the following steps to
resolve the issue.
Check that the DC plug and jack used by the external power supply are firmly connected and that the

POWER LED's on both the transmitter and receiver are both illuminated.
Check that the Cat.5e/6 or higher cable is seated correctly and that the DATA LED on the receiver is

illuminated.
Check that all HDMI connections between the source device, transmitter, receiver and displays are

seated correctly and secure.
Power off all of the devices, then power on in this order: first the transmitter & receiver, followed by

the display(s) and finally the source device.
For some HDMI devices it may be helpful to unplug and replug their HDMI connection to re-initiate

the HDMI handshake and recognition.
Check the length of the Cat.5e/6 or higher cables against the table shown in the installation section

of this manual. Reduce the lengths if necessary or use a higher quality cable.
Check the lengths of the input and output HDMI cables used against the maximum recommended

lengths in the "Specification". Please consider reducing the length or using a higher quality cable.
English