Maintenance And Cleaning - UFESA MI1400 ELITE Manual De Instrucciones

TROUBLESHOOTING
N.º Troubles
1 The machine doesn't work
Noise in the mixing bowl
2 when working (the accessory
scraped the bowl)
The machine doesn't work on
3
certain speed
Movements when the machine
4
working
The rise button didn't spring
5 back in place after installing
the mixing bowl and pot cover
TABLE OF RECIPES
Load
Flour: 1000g
Water: 538g

MAINTENANCE AND CLEANING

Before cleaning, always turn off the appliance and unplug it from the power supply.
Do not immerse the appliance and power cord in water or other liquids or wash them in the di-
shwasher.
Prompt: it is suggested that clean the appliance immediately after use, which is easy for cleaning.
In the event of disassembling the appliance, rotate the appliance on the opposite direction of
installation direction.
When disassembling all mincing chamber or body of shredder, press on the lock button 1 with one
hand and screw off the mincing chamber or body of shredder with the other hand as the direction
of the arrow shown in the right picture.
Please be careful for the disassembly of the appliance, so as not to scratch your fingers.
Do not use abrasives, scrubbers, acetone and alcohol to clean juicer.
Since some parts are relatively sharp, clean them with a brush, so as not to scratch fingers;
Neither immerse the motor in water, nor rinse it under the water tap. Water temperature for clea-
ning should not exceed 60 ° C.
Only plastic parts are suitable for dishwashing machine.
It is forbidden to wash metal accessories in the dishwasher, as the aggressive cleaning agents used
16
·Check if the machine works continuously more than 10 minutes,
·Check if the mark on speed knob correspond to the speed silks-
·Rotate speed knob to 0 ,and re-check if the machine works .
·Check if the machine is placed on a smooth and flat tabletop.
·Check if the pot cover placed on the machine properly.
Time
5' Dough hook
·Check if the plug is in good contact with the socket.
·Check if the rise button spring back in place.
and wait until the motor cool down.
·Check if the mixing bowl is properly installed.
·Check if the accessory installed properly on machine.
creen on housing.
·Check if the anti-slip feet fall off.
·Check if the mixing bowl is properly installed.
Accessory
Solution
Speed
Progressive:
30'' at Speed 1
30'' at Speed 2
4' at Speed 3