Trixie TX6 Manual De Instrucciones página 5

• The programming has to be completed within 10 minutes.
If this is not the case, the red LED light continues to flash
to remind you that the setting has not been completed.
If you do not attempt a new setting, the device will work
according to the existing settings. If you have not set any
meal, the device works according to the preset times
(6:00 A.M., 12:00 P.M., 6:00 P.M.). This ensures that your
pet is not left hungry with no food at all.
• If the meal size is 240 ml or less, one cavity is enough to
serve the desired meal. If the meal size is more than
240 ml, e.g. 360 ml, you need 2 cavities, one full and one
half full.
• If the meal size is more than one cavity, there is a waiting
time of 10 minutes before the next cavity opens.
Changing the programming:
• If you want to change the programming, keep ENTER
pressed for 3 seconds. MEALS flashes and you are in
setting mode. Press ENTER again and you can change the
settings for the meals with the arrow buttons.
• If you want to change the time, keep ENTER pressed for
3 seconds. MEALS flashes and you are in setting mode.
Now press the downward arrow. When the time flashes,
press ENTER again. Now you can set the time with the
arrow buttons.
Changing the batteries:
When battery power is low, the red LED light flashes
slowly (once per second). Then the batteries have to
be changed. When you are away for a longer time, you
should change the batteries before you leave. Important:
after changing the batteries, you have to turn the device
on again and set the time anew. The meals you have pro-
grammed are saved in the device.
Cleaning:
The feed bowls are dishwasher safe. The top can be wiped
with a soft cloth and a mild cleaning agent. It must not be
submerged in water, as this could lead to short circuit or
electric shock and damage electronic components. Leave
all parts to dry well before you fill in new food (but not
exposed to sunshine).
Trouble shooting:
• If the display does not light up, turn the device on again.
(See corresponding section in these instructions)
• If the time flashes, there was a power failure and the time
has to be set anew (see corresponding section in these
instructions). The programmed meal times do not have to
be set again.
• If the red LED light flashes:
• Fast flashing (3 times per second) means error. You
should check the device, possibly food has blocked a
cavity.
• Slow flashing (once per second) indicates low battery
power. Change the batteries, turn the device on and set
the time anew.
Automatic Food Dispenser TX6
• Very slow flashing (once every 5 seconds) means that all
6 cavities have been served and new food has to be filled
in. After filling the cavities, press START. Then the device
will work according to the programming.
Warning
• Remove all packaging before you use the device, dispose
of all packing material properly. Some items may be
packed in poly bags. Danger of suffocation, keep out of
reach of children and pets.
• Read the instruction carefully before operating the device.
Wrong settings may lead to your pet not being fed
properly or not being fed at all.
• This feeder is for indoor use only.
• Place the feeder in a dry place on even ground.
• Do not place the feeder in a closet, in a narrow space or
close to a wall, as the top section of the feeder will rotate
to expose the food trays. Placing the feeder where there is
too little space around it may make it difficult for your pet
to access the food.
• Do not allow children to play with the feeder. Settings
may be changed or the feeder might work faultily or stop
working. Adult supervision is required when children are
near the device.
• Do not try to disassemble the feeder.
• Remove all batteries if you do not use the feeder for a
longer time.
• Do not use different types or different brands of batteries.
5