bottle.
•
Protect eyes, lungs, and skin from exposure to
detergent.
•
IMPORTANT: Store the power washer indoors
to prevent the water in the unit from expanding
under freezing conditions. When the water freezes
and expands, your power washer will be damaged
and become inoperable.
•
Never use hot water with your power
washer(40°C+). It will overheat and damage the
high-pressure pump.
•
Never leave the power washer unattended while
it is powered "on".
•
Always turn the water supply "on" before turning
the power washer power "on". Running the pump
dry will damage the internal components.
•
Never use a water supply to your power washer
exceeding 7 bar maximum.
•
Never disconnect the high-pressure hose from
the power washer while the system is pressurized.
•
Never permanently engage the trigger
mechanisms on the spray gun.
•
Never operate the power washer unless all
components are properly and securely connected.
•
Never allow the power washer pump to run for
more than one minute after turning off the water
supply. This can cause the motor and pump to
overheat and fail.
•
Only use lances and accessories that are
specified to withstand the water pressure of the
machine.
•
Never spray any electrical outlet with your power
washer.
•
Inspect the power cord before use. Do not use
it if damaged.
•
If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid
hazardous situations.
CAUTION: Read the instructions before
using the machine.
•
The machine should not be used by children.
Children should be supervised to ensure that they
do not play with the machine.
•
The appliance can be used by people with
reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, if they have
been given supervision or instruction concerning
use of the appliance in a safe way and understand
the hazards involved.
•
The electric supply connection must be made by
a qualified electrician and comply with the pressure
washer's specifications. It is recommended that
the electric supply to this machine should include
either a residual current device that will interrupt
the supply if the leakage current to earth exceeds
30 mA for 30 ms or a device that will prove the
earth circuit.
•
WARNING: This machine has been designed
for use with the cleaning agent supplied or
recommended by the manufacturer. The use of
other cleaning agents or chemicals may adversely
affect the safety of the machine.
•
WARNING: High pressure jets can be
dangerous if misused. The jet must not be directed
at persons, live electrical equipment or the machine
itself.
•
WARNING: Do not use the machine within
range of people unless they wear protective
clothing.
•
WARNING: Do not direct the jet against
yourself or others in order to clean clothes or
footwear.
•
WARNING: Risk of explosion – Do not spray
flammable liquids.
•
WARNING: High pressure hoses, fittings
and couplings are important for the safety of the
machine. Use only hoses, fittings and couplings
recommended by the manufacturer.
•
WARNING: To ensure machine safety, use
only original spare parts from the manufacturer or
approved by the manufacturer.
•
WARNING: Water that has flowed through
back-flow valves is considered non-potable.
•
WARNING: The machine shall be disconnected
from its power source by removing the plug from
the socket-outlet during cleaning or maintenance
and when replacing parts.
•
WARNING: Do not use the machine if a supply
cord or important parts of the machine, are
damaged, e.g. safety devices, high-pressure hoses,
trigger gun.
•
WARNING: Inadequate extension cords can be
dangerous. If an extension cord is used, it must be
suitable for outdoor use, and the connection must
be kept dry and off the ground. It is recommended
to accomplish this by using a cord reel that keeps
the socket at least 60 mm above the ground.
•
WARNING Always switch off the mains
disconnecting switch when leaving the machine
unattended.
Servicing of a Double-Insulated Appliance
In a double-insulated product, two systems of
insulation are provided instead of grounding.
Grounding means are not provided for a double-
insulated product, nor should grounding means be
added to the product.
Servicing a double-insulated product requires
extreme care and knowledge of the system and
5