Mounting The Camera - FeiYu Tech SCORP-C Guia De Inicio Rapido

2.2 Adjust the gimbal position to gimbal balancing position
The gimbal is folded by default, please unlock all the three axes and adjust the gimbal position
to gimbal balancing position, and then lock the three axes.
3
2
1
Gimbal folded position

3. Mounting the Camera

Before mounting the camera, make sure the camera is ready for shooting (Install the camera
lens, and the lens cover should be removed, the memory card and battery needs to be
inserted to the camera, and battery is fully charged) , complete all the steps which mentioned
in chapter "2. Getting started" and the gimbal is adjusted to
Make sure the gimbal is powered off or in sleep mode before mounting the camera.
3.1 Attach the quick release plate and camera backing base(Optional)
Attach the quick release plate to camera by tightening the screw.
User can choose to attach the camera backing base if needed ( For example, when using a
long or heavy lens). Attach the camera backing base to camera, then attach it to quick release
plate by tightening 2 screws.
Attach with quick release plate only
Gimbal balancing position
gimbal balancing position.
Attach with camera backing base and quick
release plate
EN
3.2 Install lens holder (Optional)
Install the lens holder on the quick release plate if needed, the rubber of the lens holder must
be directly under the lens. It is recommended to use the lens holder when using a long or
heavy lens.
3.3 Mount camera on gimbal
Unlock the quick release plate safety lock
the slot ② in direction of icon, lock the safety lock
is recommended to push the camera against the tilt axis. Unlock the slider lock
the camera left or right according to camera's width, then lock the slider lock
3
- 5 -
① , install the plate with the mounted camera into
① once the camera is roughly balanced. It
③
1
2
!
3
③ to move
.