FeiYu Tech SCORP-C Guia De Inicio Rapido página 6

4. Gimbal Balancing
Please balance the gimbal before shooting. Make sure the camera and
lens are ready for shooting, and the gimbal is powered off or in sleep
mode before balancing. It is recommended to hold up the camera
first, then move the slide arm, cross arm and vertical arm.
4.1 Balancing the tilt axis
4.1.1 Balancing the vertical tilt
a. Unlock the tilt lock ① , and loosen the slide arm
lock knob ② .
b. Rotate the tilt axis so that the camera lens is pointing
upward. Check the direction which the lens tilts to.
c. If the lens tilts to one side, then the camera is that
side heavy, move the slide arm ③ to the opposite
direction, until the camera is steady pointing upward.
d. Tighten the slide arm lock knob ② while holding the
camera.
4.1.2 Adjust depth for the tilt axis
a. Rotate the tilt axis so that the camera lens is pointing
forward. Check the direction which the lens tilts to.
b. If the lens tilts to one side, then the camera is that
side heavy, unlock the quick release plate safety lock
and then move the quick release plate to the opposite
direction, until the camera is steady pointing forward.
c. Lock the quick release plate safety lock ①
holding the camera.
The tilt axis is balanced when the camera is steady
while tilted up or down by 45° .
4.2 Balancing the roll axis
a. Unlock the roll lock ① , check the direction which the
camera tilts to.
b. If the camera tilts to one side, then the camera is that
side heavy, loosen the cross arm lock knob
move the cross arm to the opposite direction, until the
camera can stay still and horizontal to the ground.
c. Tighten the cross arm lock knob ② .
The roll axis is balanced when the camera can stay still
and horizontal to the ground.
Tutorial Videos
2
3
2
①
while
1
2
② and then
3
1
EN
4.3 Balancing the pan axis
a. Unlock the pan lock
and tilt the gimbal forward until it is
horizontal to the ground.
b. If the camera tilts to one side, then the
camera is that side heavy, loosen the vertical
arm lock knob ② and then move the vertical
arm ③ to the opposite direction, until the
camera can stay still and horizontal to the
ground.
c. Tighten the vertical arm lock knob
The pan axis is balanced when the camera
can stay still and horizontal to the ground.
5. Operation
1
5.1 Power ON/ OFF
Before power on the gimbal, make sure you have balanced gimbal, and unlocked all the three
axes. If you haven't unlocked all the 3 axes, gimbal will enter sleep mode to protect itself.
Please single tap power button to wake up gimbal after unlocked all the 3 axes.
! Please set motor power first after powering on gimbal for the first time or after changing a
new camera/lens.
Long press the power button and release it when you hear the beep sound to power on/ off.
5.2 Follow mode introduction
PF: Pan follow, only the pan axis follows the movement of user's hand.
PTF: Pan and tilt follow, where both the pan and tilt axes follow the movement of user's hand, but roll
axis does not.
FPV: Pan, tilt and roll follow, where all 3 axes follow the movement of user's hand.
Lock: All 3 axes do not follow the movement of user's hand, gimbal keeps the direction of the camera
fixed.
FFW: Flash follow, where all 3 axes follow the movement of user's hand in high follow speed.
- 6 -
① . Hold the tripod,
2
② .
1
3