Aqara E1 Manual De Instrucciones página 10

This product can be configured on the app to open and close the curtains
according to the intensity of ambient light. To use the function, the light
sensor should face the outside of the window and the Curtain Driver
should be installed on the side near the window. If you need to control
the opening and closing of curtains according to the light indoor, the light
sensor should face the interior and the Curtain Driver should be installed
on the side near the interior. To optimize the e ect of the light sensor,
please ensure that there is no opaque object in front of it.
Install clips and rubber strip (for curtains suitable for
Grommets)
1. First, measure the number of holes "N" between the outer edges of two
adjacent Grommets with the rubber strip as shown in the figure below
(measure the shortest straight-line distance between the outer edges of
the Grommets);
2. Install the first clip onto the third hole from the le of the rubber strip,
and install all the other clips according to the following instructions.
1 2 3
Reserve 5 holes between the second and first clips, and the number of
holes between the other adjacent clips is "N×2" (including the hole
occupied by the clip)
1 2 3
Grommets
罗马圈
Turn the rubber strip up
to place it in the groove.
06
...
N
Grommets
罗马圈
1 2 3