Aqara E1 Manual De Instrucciones página 8

Note: This product is only applicable to rods with uniform thickness, not
to those with di erent thicknesses at the ends, such as telescopic rods.
The Rods shall be provided with
close-fitting decorative caps.
Quick Start Guide
Please read the following steps to start using the product.
Preparation before use
1.This product needs to be connected with the Aqara Home app before
being installed on the curtains.
2.Before activating the product, please make sure you have the Aqara
Home app and the Aqara Zigbee 3.0 hub installed (Please scan the QR
code below to download the app).
3.Please open the app, tap "Home" and then tap "+" in the top right
corner to enter the "Add Device (Accessory)" page. Select "Curtain
Driver E1" and the hub to be connected to, and add it according to
instructions in the Aqara Home app. Press and hold the Setting button
for 5 seconds, and wait for the voice prompt from the Hub.
4.If you have purchased two or more Curtain Drivers, please connect all of
them to the Aqara Home app before further installation.
5.If you use double-sided curtains, it is necessary to connect two Curtain
Drivers to the app and then put them in one group for simultaneous
control. Enter the main page of the Curtain Driver to be grouped, click
"... " in the upper right corner, select "Create a group for Curtains" and
follow the instructions.
6.It is recommended to fully charge the product before installation.
7.The mass and the dimension of the curtain to be driven shall be compati-
ble with the rated torque and rated operating time.
04