Installing The Blades; Installing The Light Mounting Plate - Hinkley 54 VELO Manual De Instrucciones

INSTALLING THE BLADES

Blade
Fig. 1

INSTALLING THE LIGHT MOUNTING PLATE

1
2
3
4
5
Blade Support Plates
Screws with Lock Washers
Using the included screwdriver, attach the blade to motor
1
using the blade support plates and screws with lock washers
as shown in Figure 1. Tighten screws.
2
Repeat process with remaining blades.
NOTE:
Cordless power screwdrivers are NOT recommended,
as they usually strip the heads of the screws and
usually will not fully compress the lock washers on
the motor screws. Use a large flat blade screwdriver
for final tightening to fully compress the washers. This
will help ensure proper alignment of the blades and
noise-free, wobble-free running.
Light mounting plate
Fig. 1
Mounting hub
Screws
©2021 Hinkley Lighting, Inc. | hinkley.com | 09