Installing The Blades; Installing The Light Kit Pan - Hinkley 66 CONCUR Manual De Instrucciones

INSTALLING THE BLADES

NOTE:
Remove any rubber supports that are
installed for shipping.
Attach blade to blade bracket using screws provided. Repeat for
1
the two remaining screws.
Tighten each screw securely.
2
3 Fasten the blade assembly to the motor by tightening the motor
screws. Please note that the motor screws are pre attached into
the blade brackets.
4 Repeat steps 1,2 & 3 for the remaining blades.

INSTALLING THE LIGHT KIT PAN

CAUTION: To reduce the risk of electrical shock, disconnect the
electrical supply circuit to the fan before installing the light kit.
Loosen but do not remove two of three mounting screws from
1
the fan motor assembly; Remove one mounting screw.
Push the light kit pan up to the fan motor assembly so that
2
the two loosened screw heads fit into the keyhole slots. Turn
the light kit pan clockwise, tightened the screws. Re-install the
screw that was removed in step 1 and tighten firmly.
10 hinkley.com
Screws
Blade Arm
LK Pan
Screws
Blades
Screws