Installing The Blades; Installing The Mounting Plate - Hinkley TREY 52 Manual De Instrucciones

INSTALLING THE BLADES

NOTE:
Remove any rubber supports that are installed for
shipping.
WARNING: To reduce the risk of personal injury, do not bend the blades
while installing, balancing the blades, or cleaning the fan.
Insert the blade through the slot in the housing. Align the holes in the
blade and the fan motor assembly and secure with a blade attachment
screw and fiber washer.
Repeat this procedure with the remaining blades.

INSTALLING THE MOUNTING PLATE

1 Remove one of the three screws on the mounting hub located on
the fan motor.
Loosen the other two screws.
2
Install mounting plate to mounting hub.
3
Line up the two slotted holes with the two loose screws on the
4
mounting hub located on fan motor.
5 Re-install the third screw removed and tighten all three.
Blades
Fiber
Washer
Screws
Mounting Hub
Screws
Mounting Plate
©2019 Hinkley Lighting, Inc. | hinkley.com | 09